Installation guide

— 10 —
Wall Mounting (Optional)
Follow the steps below to mount the VPort 351 on a wall or panel.
STEP
1:
Re
move the aluminum DIN-Rail attachment plate from the VPort 351, and
then
attach the wall mount plates, as shown in the diagrams below.
⇒⇒
Top
plate
Bottom
plate
STEP 2:
Mounting the VPort 351 on the wall requires 4 screws. Use
the
VPort 351, with wall mount plates attached, as a guide to
mark the correct locations of the 4 screws. The heads of the
screws should be less than 6.0 mm in diameter, and the
shafts should be less than 3.5 mm in diameter, as shown in
the figure at the right.
Do
not screw the screws in all the way—leave a space of
about
2 mm to allow room for sliding the wall mount panel
between
the wall and the screws.
6.0 mm
3.5 mm
NOTE
Test the screw head and shank size by inserting the screw into one
of the keyhole shaped apertures of the Wall Mounting Plates,
before
it is screwed into the wall.
STEP 3:
Once
the screws are fixed in the wall, insert
the
four screw heads through the large parts of
the
keyhole-shaped apertures, and then slide
VPo
rt 351 downwards, as indicated in the
figu
re. Tighten the four screws for added
stability.
2
1
2
1
Wiring Requirements
ATTENTION
Safety First!
Be
sure to disconnect the power cord before installing and/or
wi
ring your MOXA VPort 351.
Calculate
the maximum possible current in each power wire and
common wire. Observe all electrical codes dictating the
maximum current allowable for each wire size.
If the current goes above the maximum ratings, the wiring could
ove
rheat, causing serious damage to your equipment.