Installation guide

DIN-Rail Mounting (Optional)
The VPort 251 can be mounted on a 35-mm DIN-rail using the DK-35A
accessory (ordered separately).
Wall Mounting
The VPort 251 can be mounted on the wall with 2 screws.
Make sure that screws are less than 3.5 mm in diameter, with
heads between 3.5 and 6.0 mm in diameter, as shown on the
right.
6.0 mm
3.5 mm
VPort 251
1-Channel Video Encoder
Wiring Requirements
ATTENTION
Safety First!
Be sure to disconnect the power cord before installing or wiring
the VPort.
Determine the maximum current for each power wire and
common wire. Observe all electrical codes dictating the
maximum current allowed for each wire size.
If the current exceeds the maximum ratings, the wiring could
overheat, causing serious damage to your equipment.
- 10 -