User`s manual

VPort D351 User’s Manual System Configuration
Server 1, 2, 3, 4
Input the sendalarm.cgi command, video source’s user name, and password.
The sendalarm.cgi command should have the form http://IP address or domain name/
moxa-cgi/sendalarm.cgi.
Step 2: Set up the alarm to Send message via HTTP Event Servers.
Enable the alarm condition
The Vport 351 supports video motion detection, digital input, and video loss alarm conditions.
Trigger Condition
Select the condition for triggering the alarm
Trigger Action
Choose the Send message via HTTP Event Servers for sending the alarm message to VPort
D351
HTTP Action Settings
In this section, select Server 1, 2, 3, or 4 for the target HTTP Event Server, and then input the
alarm message being sent. Two messages should be listed.
1. Cameraidx=xxxx or Idx=xxxx is for identifying the video source.
¾ Cameraidx is the camera channel number of the video source. Since the VPort 351 is a
1-channel video encoder, Cameraidx = 1.
¾ Idx is the channel index of this video source in the VPort D351’s video source list. For
example, if this VPort 351 is indexed in number 5 of the VPort D351’s video source list,
then Idx = 5.
4-2