User`s manual

VPort D351 User’s Manual Technical Specifications
NOTE
The system parameter import/export functions allow the administrator to back up and restore
system configurations. The Administrator can export this sys_config.ini file (in a special binary
format) for backup, and import the sys_config.ini file to restore the system configurations of the
VPort. System configurations will be changed immediately after the VPort is rebooted.
Firmware Upgrade
Take the following steps to upgrade the firmware:
Step 1: Press the Browse button to select the firmware file.
NOTE
For VPort D351, the firmware file extension should be .rom.
Step 2: Click on the Upgrade button to upload the firmware to the VPort.
Step 3: The system will start the firmware upgrade process.
Step 4: Once Firmware Update Success…..Reboot.... is shown, wait a few seconds for the VPort
to reboot. The reboot process is finished once the STAT LED is lit continuously in green.
NOTE
Firmware upgrade will not change the original settings.
Reset to Factory Default
Reset to the factory default by clicking on the OK button (as shown in the following figure).
NOTE
All parameters will be reset to factory defaults when you use the Factory Default function. For
this reason, if you want to keep a digital copy of the current configuration, remember to export
the sys_config.ini file before using the Factory Default function.
Reboot
From the “Device Reboot” page, click OK (as shown in the following figure) to restart the VPort’s
operating system.
A-7