User`s manual

VPort 2141 Video Encoder User’s Manual URL Commands for VPort 2141

A-3

Return:

HTTP/1.0 200 OK\r\n

Content-Type: text/html\r\n

Context-Length: <length>\r\n

\r\n

where <parameter pair> is

<parameter>=<value>\r\n

<length> is the actual length of content.

Example: request IP address and it’s response

Request:

http://192.168.0.123/cgi-bin/admin/getparam.cgi?network_ipaddress

Response:

HTTP/1.0 200 OK\r\n

Content-Type: text/html\r\n

Context-Length: 33\r\n

\r\n

network.ipaddress=192.168.0.123\r\n

Set server parameter values

Note: This request requires administrator access

Method: GET/POST

Syntax:

http://<servername>/cgi-bin/admin/setparam.cgi? [nosync=<value>&]<parameter>=<value>

[&<parameter>=<value>…][&return=<return page>]

parameter value description

nosync 0, 1 Specifies that there should be no sync (write) of the

corresponding configuration file on flash. If parameter is

omitted, a sync write will occur.

(note: this parameter must be put at begin of parameter

list)

<group>_<name>.

value to assigned Assign <value> to the parameter <group>_<name>..

return <return page> Redirect to the page <return page> after the parameter is

assigned. The <return page> can be a full URL path or

relative path according the the current path. If you omit

this parameter, it will redirect to an empty page.

(note: The return page can be a general HTML

file(.htm, .html) or a Vivotek server script executable

(.vspx) file. It can not be a CGI command. It can not have

any extra parameters. This parameter must be put at end

of parameter list)