User`s manual

V460 Series WinCE User’s Manual Getting Start
2-3
Step1: Scan Disk (Automatically)
The system will scan the disk automatically when you start the reset procedure.
Step2: Reset to Default? (Y/N)
After the disk scan is complete, the system will ask you to confirm that you want to reset to
defaults.
Press Y to reset to defaults. This will revert all settings to the factory default values.
Step3: Clean all files and directories? (Y/N)
You will be asked whether you want to delete all files and directories. Press Y if you would like to
delete all files in the “Program Files” directory.
Step4: Proceed? (Y/N)
You will be asked to confirm. Press Y to proceed to the reset process.
NOTE: After the disk scan finishes, you may find some files named FILE00xx.chk. This means
that some files or directories were damaged and have been fixed.
Changing the Network Settings
The V460 computer comes with two network interfaces. The default IP addresses and netmask of
the network interfaces are as follows:
Default IP Address Netmask
LAN 1
192.168.3.127 255.255.255.0
LAN 2
192.168.4.127 255.255.255.0
LAN 3
192.168.5.127 255.255.255.0
LAN 4
192.168.6.127 255.255.255.0
The V462 has 2 LAN ports and the V464, V466, and V468 have 4 LAN ports by default. There
are two ways to change the network settings.
Use Windows CE Network Control Panel utility
Network interface settings can be configured with the Windows utility.
1. Go to [Start] Æ [Settings] Æ [Network and Dial-Up Connections]. You will see all
network interfaces of the system.