User`s manual

V460 Series WinXP Embedded User’s Manual Getting Started
Starting Your V460-XPE Computer
Connect the CRT monitor or LCD monitor to the target computer, and then power it up by
connecting it to the power adaptor. It takes about 30 to 40 seconds for the system to boot up. Once
the system is ready, the Desktop will appear on your monitor.
Resetting Your V460-XPE Computer
y Reset Button
A Reset button is located on the front panel of V460-XPE. Press the reset button to shut down
your V460, just as you would do with a standard PC.
y Software Shutdown / Reboot
Click Start Æ Shutdown to reboot or shutdown the V460-XPE computer.
Changing the Network Settings
The V460-XPE computer comes with two network interfaces. Both of the default IP addresses are
DHCP. Choose My Device Æ Control panel Æ Network Connections to enter the network
settings page. Select the connection and choose an option on the pop-up menu by right-clicking.
You can specify the IP address manually or by DHCP. In addition, you can disable or enable either
one or both connections with the pop-up menu.
2-2