User`s manual

MC-4510-C23 HW User’s Manual Hardware Connection Description
3-2
Installing the MC4510-C23
Wall or Cabinet Mounting
The MC-4510-C23 has been pre-installed with two brackets on both ends of the computer. Use
two screws per side to attach the MC-4510-C23 to a wall or cabinet.
Step 1: Use two screws for each bracket and attach the bracket to the rear of the MC-4510-C23.
Screws
Screws
Wiring Requirements
This section describes how to connect serial devices to the embedded computer.
You should read and follow these common safety precautions before proceeding with the
installation of any electronic device:
y Use separate paths to route wiring for power and devices. If power wiring and device wiring
paths must cross, make sure the wires are perpendicular at the intersection point.
NOTE: Do not run signal or communication wiring together with power wiring in the same
wire conduit. To avoid interference, wires with different signal characteristics should be routed
separately.
y Use the type of signal transmitted through a wire to determine which wires should be kept
separate. The rule of thumb is that wiring that shares similar electrical characteristics can be
bundled together.
y Keep input wiring and output wiring separate.
y It is advisable to label the wiring to all devices in the system.