Hardware manual

V2101 Hardware Hardware Connection Description
3-3
Step 2: Use two screws per side to attach the V2101 to a wall or cabinet.
VESA Mounting (not included in the Package)
The V2101 has four screw holes on the bottom panel for attaching the computer to a 75 x 75 mm VESA
mounting kit. Use four screws to attach the computer to the VESA mounting kit.
Warning
The screw holes for the mount points are approximately 3 mm deep. Users should take extreme care to ensure
that any screws used to
mount the enclosure do not penetrate more than 1 mm into the device enclosure.
Screws which penetrate more than 1 mm into the enclosure may come into contact with
components on the PCB, shorting out the device and permanently damaging the internals.
Taking
the 3 mm depth of the mounting holes, plus 1 mm of internal leeway, any screws used to mount the V2101
should penetrate no more than a total of 4 mm beyond the external face of the device.
Wiring Requirements
This section describes how to connect serial devices to the embedded computer.
You should read and follow these common safety precautions before proceeding with the installation of any
electronic device:
• Use separate paths to route wiring for power and devices. If power wiring and device wiring paths must
cross, make sure the wires are perpendicular at the intersection point.
NOTE: Do not run signal or communication wiring together with power wiring in the same wire conduit. To
avoid interference, wires with different signal characteristics should be routed separately.
• Use the type of signal transmitted through a wire to determine which wires should be kept separate. The
rule of thumb is that wiring that shares similar electrical characteristics can be bundled together.
• Keep input wiring and output wiring separate.