User`s manual

ioLogik E1200 Series Introduction
1-5
Peer-to-peer I/O communication over Ethernet
In some remote automation implementations, the control room and sensors are located quite far away from
each other, often with only a single remote I/O module. Peer-to-peer communication has little or no limitation
as it replaces cable by integrating multiple I/O signals over a single network cable to transmit input-to-output
controls without the aid of PLCs or controllers. Featuring peer-to-peer communications and support for
channel-to-channel mapping, the ioLogik E1200 allows simultaneous multiple target transmissions. In addition,
the ioLogik E1200 supports up to 16 channels for transmission over Ethernet (based on an emitter and receiver
I/O pair).