User`s manual

ioLogik E1200 Series Using the Web Console
3-23
AO Safe Mode Settings
When a peer-to-peer rule of the local AO channel is not valid, the local AO channel will enter safe mode. You can
either set the AO safe value from 0-4095 or enable Hold Last Status during Safe Mode.
Change Password
For all changes to the ioLogik E1200’s password protection settings, you will first need to enter the old
password. Leave this blank if you are setting up password protection for the first time. To set up a new
password or change the existing password, enter your desired password under both New password and
Confirm password. To remove password protection, leave the New password and Confirm password
fields blank.
ATTENTION
If you forget the password, the ONLY way to configure the ioLogik E1200 is by using the reset button to load
the factory defaults.
Before you set a password for the first time, it
is a good idea to export the configuration to a file when you have
finished setting up your ioLogik E1200. Your configuration can then be easily imported back into the ioLogik
E1200 if you need to reset the ioLogik E1200 due to a forgotten password or for
other reasons.
Load Factory Defaults
This function will reset all of the ioLogik E1200’s settings to the factory default values. All previous settings,
including the console password will be lost.