User`s manual

ioLogik E1200 Series Using the Web Console
3-5
User-defined Modbus Addressing
The input and output address can be configured in a different format on a specific settings page. Check the
“Enable User-defined Modbus Addressing” box, select the Modbus function, and then configure the start
address of each item.
Default Modbus Address
On the settings page, you can view the default Modbus address for all I/O devices. The page only displays the
start address of each item. For example, if the DI Value starts from 10001, then the 1
st
DI channel’s Modbus
address is 10001 and the 2
nd
DI is 10002. Please refer to the diagram at the top of the following page.
ATTENTION
Disable the user
-defined modbus addressing function if using the MXIO(.NET) library or using Active OPC
Server to control or monitor the ioLogik E1200’s I/O Status.