User`s manual

UC-8410/8416/8418-LX User’s Manual Managing Communication
4-19
Setup 1: Ethernet Bridging for Private Networks on Different Subnets
1. Set up four machines, as shown in the following diagram.
Host A (B) represents one of the machines that belongs to OpenVPN A (B). The two remote
subnets are configured for a different range of IP addresses. When this setup is moved to a
public network, the external interfaces of the OpenVPN machines should be configured for
static IPs, or connect to another device (such as a firewall or DSL box) first.
# openvpn --genkey --secret secrouter.key
Copy the file that is generated to the OpenVPN machine.
2. The openvpn-bridge script file located at “/etc/openvpn/” reconfigures the interface “eth1” as
IP-less, creates logical bridge(s) and TAP interfaces, loads modules, and enables IP
forwarding.
#---------------------------------Start-----------------------------
#!/bin/sh
iface=eth1 # defines the internal interface
maxtap=`expr 1` # defines the number of tap devices. I.e., # of tunnels
IPADDR=
NETMASK=
BROADCAST=
# it is not a great idea but this system doesn’t support
# /etc/sysconfig/network-scripts/ifcfg-eth1
ifcfg_vpn()
{
while read f1 f2 f3 f4 r3
do
if [ “$f1” = “iface” -a “$f2” = “$iface” -a “$f3” = “inet” -a “$f4” =
“static” ];then
i=`expr 0`
while :
do
if [ $i -gt 5 ]; then
break
fi
i=`expr $i + 1`
read f1 f2