User`s manual

UC-8410/8416/8418-LX User’s Manual Getting Started
2-2
Powering on the UC-8410/8416/8418
Connect the SG wire to the Shielded Contact located in the upper left corner of the
UC-8410/8416/8418, and then power on the computer by connecting it to the power adaptor. It
takes about 30 to 60 seconds for the system to boot up. Once the system is ready, the Ready LED
will light up.
ATTENTION
After connecting the UC-8410/8416/8418 to the power supply, it will take about 16 seconds for
the operating system to boot up. The green Ready LED will not turn on until the operating
system is ready.
Connecting the UC-8410/8416/8418 to a PC
There are two ways to connect the UC-8410/8416/8418 to a PC: directly through the serial console
port, or by Telnet over the network.
Serial Console
The serial console port gives users a convenient way of connecting to the UC-8410/8416/8418’s
console utility. This method is particularly useful when using the computer for the first time. The
signal is transmitted over a direct serial connection, so you do not need to know either of its 3 IP
addresses in order to connect to the UC-8410/8416/8418.
Use the serial console port settings shown below.
Baudrate
115200 bps
Parity
None
Data bits
8
Stop bits
1
Flow Control
None
Terminal
VT100