User`s manual

2
2
Chapter 2 Getting Started
In this chapter, we show how to use a PC to operate your UC-7400-CE embedded computer. For
clarity, the PC you use to connect to the embedded computer is called a development workstation,
and the UC-7400-CE embedded computer is called a target computer.
In addition, we explain operations such as system time adjustment, troubleshooting network
connectivity, etc. Some of these operations can be done using system commands after gaining
access to the computer, and others can be done using a web-based management system. The
web-based management system is described in a later chapter.
The following topics are covered in this chapter:
 Starting the UC-7400-CE
 Resetting the UC-7400-CE
 Operating the UC-7400-CE from the Serial Console
 Changing the Network Settings
 Operating the UC-7400-CE by Telnet
 User/Group Management
 Adjusting the System Time and RTC Time
 Troubleshooting Network Connectivity
 Simple Network Management Protocol (SNMP)