User`s manual

UC-7112-LX Plus Software User’s Manual Programmer’s Guide
6-3
The buzzer’s on / off behavior is controlled by software. If you call the “ioctl” function, you
MUST set the frequency at 100 Hz. If you use a different frequency, the system could crash.
WDT (Watch Dog Timer)
1. Introduction
The WDT works like a watch dog function. You can enable it or disable it. When the user
enables WDT but the application does not acknowledge it, the system will reboot. You can set
the ack time from a minimum of 50 msec to a maximum of 60 seconds.
2. How the WDT works
The sWatchDog is disabled when the system boots up. The user application can also enable
ack. When the user does not ack, it will let the system reboot.
Kernel boot
…..
….
User application running and enable user ack
….
….
3. The user API
The user application must
include <moxadevic.h>, and link moxalib.a. A makefile example
is shown below:
all:
arm-linux-gcc –o xxxx xxxx.c -lmoxalib
int swtd_open(void)
Description
Open the file handle to control the sWatchDog. If you want to do something, you must first
open and save the file handle before doing anything else.
Input
None
Output
The return value is the file handle. If there is an error, it will return a value of < 0.
Use errno() to get the error number.
int swtd_enable(int fd, unsigned long time)
Description
Enable application sWatchDog. You must issue the ack command after this process.
Input
int fd - the file handle, from the swtd_open() return value.
unsigned long time - The time you wish to ack sWatchDog periodically. You must ack the
sWatchDog before timeout. If you do not ack, the system will be reboot automatically. The
minimal time is 50 msec, the maximum time is 60 seconds. The time unit is msec.