User`s manual

UC-7112-LX Plus Software User’s Manual Getting Started
2-7
Installing a Secure Digital (SD) Memory Card
The UC-7112-LX Plus has an internal SD socket for storage expansion. Moxa provides an SD
flash disk for plug & play expansion that allows users to plug in a Secure Digital (SD) memory
card compliant with the SD standard V1.0 for up to 1 GB of additional memory space. In this
section, we explain how to install the SD card in the UC-7112-LX Plus.
The SD slot is located on the right side of the UC-7112 Plus enclosure. To install an SD card, you
must first remove the upper enclosure of the UC-7112-LX Plus to access the slot, and then plug
the SD card directly into the slot.
The SD card will be mounted at /mnt/sd. Detailed installation instructions are shown below:
Step 1: Loosen the screws on the sides of the UC-7112-LX Plus’s outer casing.
Step 2:Remove the UC-7112-LX Plus’s outer cover.
Step 3: The SD socket is located on the back of bottom board. Insert the SD memory card as
shown in the figure.
NOTE: To remove the SD card from the slot, press the SD card in slightly with your finger, and
then remove your finger to cause the card to spring out partially. You may now grasp the top of the
card with two fingers and pull it out.
Before removing the SD card, remember to type /sync to ensure that your data has been written.