User`s manual

UC-7112 Plus/7112/7110 Hardware User’s Manual Hardware Connection Description
3-3
ATTENTION
This product should be mounted on a well-grounded mounting surface such as a metal panel.
V+V-
SG
12-48V
SG: The Shielded Ground (sometimes called
Protected Ground) contact is the left most contact
of the 3-pin power terminal block connector when
viewed from the angle shown in the figure at the
left. Connect the SG wire to an appropriate
grounded metal surface.
Connecting Data Transmission Cables
This section describes how to connect the UC-71xx to the network, to serial devices, and to a
serial COM terminal.
Connecting to the Network
Connect one end of the Ethernet cable to the UC-71xx’s 10/100M Ethernet port, and the other end
of the cable to the Ethernet network. If the cable is properly connected, the UC-71xx will indicate
a valid connection to the Ethernet in the following ways:
y The top-right LED on the connector glows a solid green when connected to a 100 Mbps
Ethernet network.
y The top-left LED on the connector glows a solid orange when connected to a 10 Mbps Ethernet
network.
y The LEDs will flash when Ethernet packets are being transmitted or received.
The 10/100 Mbps Ethernet LAN 1 and LAN 2 ports use 8-pin RJ45 connectors. Pinouts for these
ports are given in the following diagram.
8-pin RJ45
18
100 Mbps
indicator
10 Mbps
indicator
Pin Signal
1 ETx+
2 ETx-
3 ERx+
4 ---
5 ---
6 ERx-
7 ---
8 ---