User`s manual

UC-7101/7110/7112 Software User’s Manual Getting Started
Telnet
If you know at least one of the two IP
addresses and netmasks, then you can use
Telnet to connect to the
UC-7101/7110/7112’s console.
Default IP Address Default Netmask
LAN 1
192.168.3.127 255.255.255.0
LAN 2
192.168.4.127 255.255.255.0
Telnet can be used locally by using a crossover Ethernet cable to connect your computer to the
UC-7101/7110/7112, or over a LAN or the Internet. The default IP addresses and netmasks are
shown above. To login, type the Login name and password as requested. The defaults are:
Login: root
Password: root
Once you open the “msh command shell” you can proceed to configure the UC-7101/7110/7112’s
network settings, as described in the next section.
ATTENTION
y Serial Console Reminder: Remember to choose VT100 as the terminal type. Use the cable
CBL-RJ45F9-150 that comes with the UC-7101/7110/7112 to connect to the serial console
port. If you are not able to connect on the first try, unplug and then re-plug the
UC-7101/7110/7112’s power cord.
y Telnet Reminder: When connecting to the UC-7101/7110/7112 over a LAN, configure your
PC’s Ethernet card to be on the same subnet as the UC-7101/7110/7112 you wish to contact.
2-3