Installation guide

- 8 -

DIN-Rail Mounting (optional)

Use a pair of optional DK

-DC50131

DIN

-Rail mounting kits (must be

purchase

d separately) to mount the

-5510 on a 35 mm DIN-Rail.

STEP 1:

Use 12 screws (6 screws per plate) to

attach the two DIN

-Rail attachment

plates to the rear panel of the switch

STEP 2:

If the spring-loaded bracket is locked in place, push the recessed button

to release it. Once released, you should feel some resistance from the

spring as you slide the bracket up and down a few millimeters in each

direction.

STEP 3:

Insert the top of the DIN

-Rail into

the top slot of the DIN

-Rail

attachment plates.

STEP

The DIN

Rail attachment plates will

snap into position, as shown in the

figure below.

To remove the Moxa ToughNet Switch from the DIN-Rail, use a

screwdriver to pull down the bottom parts of the two spring-loaded

brackets until they are fixed in the “locked” position, and then reverse

Steps 3 and 4 above.