Installation guide

- 12 -
Connecting the Data Lines
10/100BaseT(X) Ethernet Port Connection
All TN-5510 models have 8 10/100BaseT(X) Ethernet ports (4-pin
shielded M12 connector with D coding). The 10/100Base-TX ports located
on the TN-5510 front panel are used to connect to Ethernet-enabled
devices. Most users configure these ports for Auto MDI/MDI-X mode, in
which case the port’s pinouts are adjusted automatically depending on
the type of Ethernet cable used (straight-through or cross-over), and the
type of device (NIC-type or HUB/Switch-type) connected to the port.
In what follows, we give pinouts for both MDI (NIC-type) ports and MDI-X
(HUB/Switch-type) ports. We also give cable wiring diagrams for
straight-through and cross-over Ethernet cables.
Pinouts for the 10/100BaseT(X) Ports on the TN-5510.
Pinouts for the 1000BaseLSX Q-ODC Gigabit Fiber port
Mating Sequence
Push plug slightly into
connector socket
Rotate to find keying
position
Unmated – push
connector to mate
Mated – connector snaps
in and is fully strain
relieved
Pull coupling ring to
unmate
M12 (4-pin, M) to M12 (4-pin, M) Cross-Over Cable Wiring