Installation guide

- 6 -

Panel/Wall Mounting

Mounting the TN-5308-LV/MV on the wall requires 3 screws. Please use

the 3 screws packed in the panel mounting kit.

STEP 1: Prepare the 3 screw holes on the wall according to the positions

of the 3 screw holes on the switch shown on the mounting dimension

diagram.

STEP 2: Use one screw to go through the top-middle screw hole on the

switch and screw it into the wall.

STEP 3: Screw in the remaining 2 screws through the bottom-left and

bottom-right holes on the switch to the wall.

NOTE

The screw lengths of TN

-5308-LV and TN-5308-

MV are different.

-5308-LV uses M3 * 30 mm screws. TN-5308-

MV uses M3 * 40

mm screws. Please use the screws packed in the panel mounting

kit.

DIN-Rail Mounting (optional)

With the optional DIN-Rail mounting kit DK-TN-5308 (must be purchased

separately), you can mount the TN-5308-LV/MV on a 35mm DIN-Rail.

STEP 1:

Fix the DIN

-Rail attachment plate onto the

rear panel of the switch as shown in the

figure at the right.

STEP 2:

Position the TN-5308-LV/MV on

the DIN-Rail, tilting to hook clamps

over the top edge of the rail.

STEP 3:

Swing the switch down fully onto

the DIN-Rail until both clamps

completely latch.

To remove the Moxa ToughNet Switch from the DIN-Rail, simply reverse

Steps 2 and 3 above.