User manual

Test Report ------------------------------------------------------------------------------11/30
Report No.: M47ET060805 (ETSI EN 300 328)
Training Research Co., Ltd., TEL: [phone], Fax: [phone]
III. Section 5.7.3: Peak Power Density
3.1 Test Result of Peak Power Density for IEEE 802.11b
Channel
Frequency
(MHz)
Ppr
(dBm)
CF
(dB)
Ant. Gain
(dB)
Ppq
(dBm)
Limit
(dBm)
Margin
(dB)
CH 01 2412 -1.03 6.57 2.00 7.54 10.00 -2.46
CH 07 2442 -0.74 6.53 2.00 7.79 10.00 -2.21
CH 13 2472 -4.39 6.74 2.00 4.35 10.00 -5.65
Uncertainty
± 1.50dB
3.2 Test Result of Peak Power Density for IEEE 802.11g
Channel
Frequency
(MHz)
Ppr
(dBm)
CF
(dB)
Ant. Gain
(dB)
Ppq
(dBm)
Limit
(dBm)
Margin
(dB)
CH 01 2412 -2.02 6.57 2.00 6.55 10.00 -3.45
CH 07 2442 -1.73 6.53 2.00 6.80 10.00 -3.20
CH 13 2472 -1.87 6.74 2.00 6.87 10.00 -3.13
Uncertainty
± 1.50dB
NOTE:
(1) For equipment using FHSS modulation, the peak power density shall be limit to
–10dBW(100mW) per 100kHz E.I.R.P.
(2) For equipment using other types modulation, the peak power density shall be limit
–20dBW(10mW) per MHz E.I.R.P.
(3) Ppr: spectrum read power density (using peak search mode), CF: correct factor,
CF: Correct Factor, AG: Antenna Gain
Ppq: actual peak power density in the spread spectrum band. Ppq = Ppr + CF + AG
(4) The value of table is worst case during test condition, includes different combination s of
transmitter rate, antenna polarity and temperature
(5) The data in the above table are summarizing the following attachment spectrum analyzer
hard copy.
(6) ETSI (2400MHz ~ 2483.5MHz),
FRANCE outdoor use limited to 10mW e.i.r.p. within the band (2454MHz ~ 2483.5MHz)