User manual
Test Report ------------------------------------------------------------------------------5/25
Report No.: M47ET060805 (ETSI EN 301 893)
Training Research Co., Ltd., TEL: 886-2-26935155, Fax: 886-2-26934440
1.3 Test Method
1. Using software provided by the manufacturer to control the EUT. The test is performed under
the specific conditions.
2. Set different channel and data rate being tested, and then making EUT to the following modes:
a) The mode of continuous transmission.
b) The receive mode.
c) The standby mode.
1.4 Configuration of System Under Test
The tests below are carried with the EUT transmitter set at high power in TDD mode. The EUT is forced
to select of output power level and channel number by computer.
Power
Source
Test-table
EUT
USB
Drive*2