User`s manual

ManualsBrandsMoxa Technologies ManualsComputer equipmentThinkCore DA-660-8-CE

ThinkCore DA-661/662/663 WinCE User’s Manual Getting Started

2-2

Starting Your DA-661/662/663 Computer

Connect the SG wire to the shielded contact located in the upper left corner of the DA-66X-CE

computer, and then power it on by connecting it to the power adaptor. It takes about 30 to 60

seconds for the system to boot up. Once the system is ready, the “Ready” LED will light up. The

light will stay lit until you shut down the computer.

Resetting Your DA-661/662/663 Computer

Cold-Start: You seldom need to perform a cold-start on a DA-66X-CE computer. In some cases,

such as when the computer stops responding, an application locks up, or you upgrade the firmware,

it may be necessary to perform a cold-start. Unplug the power line and then plug it back in again.

The computer will reboot itself immediately.

Resetting to Factory Defaults: If the computer is not working properly and you want to reset it

back to the factory default settings, press and hold the “Reset to Default” button for at least 5

seconds. The buzzer will sound while the factory default settings are being loaded. After the

factory defaults have been loaded, the computer reboots itself. Do not confuse this with the

“Reset” button. In some situations when you cannot boot the computer at all, power on the

computer and hold the “Reset to Default” button for at least 20 seconds.

Operating Your DA-661/662/663 Computer via Serial

Console

The serial console port (located next to the two LAN ports) gives users a convenient way of

connecting the development workstation to the console utility of the target computer. This method

is particularly useful when using the computer for the first time.

After you have wired a serial cable, go back to the development workstation and start a terminal

program (e.g., HyperTerminal) by using the settings shown below for the serial console port.

Baudrate

115200 bps

Parity

None

Data bits

Stop bits

Flow Control

None

Terminal

ANSI

After a successful connection, type the login name and password as requested to log on to the

computer. The default values are both admin.

Password: admin

Changing the Network Settings

The DA-66X-CE computer comes with two or four network interfaces. The default IP addresses

and netmasks of the network interfaces are as follows:

Default IP Address Netmask

LAN1

192.168.3.127 255.255.255.0

LAN2

192.168.4.127 255.255.255.0

LAN3

192.168.5.127 255.255.255.0 (DA-662 only)

LAN4

192.168.6.127 255.255.255.0 (DA-662 only)