User`s manual

PT-G7509 User’s Manual Featured Functions
3-25
The Turbo Ring Concept
Moxa developed the proprietary Turbo Ring protocol to optimize communication redundancy and
achieve a faster recovery time on the network.
The Turbo Ring and Turbo Ring V2 protocols designate one switch as the master of the network,
and then automatically block packets from traveling through any of the network’s redundant loops.
In the event that one branch of the ring gets disconnected from the rest of the network, the protocol
automatically readjusts the ring so that the part of the network that was disconnected can
reestablish contact with the rest of the network.
Initial setup for Turbo Ring or Turbo Ring V2
STAT
FAULT
PWR1
MASTER
PWR2
COUPLER
LNK/ACT SPEED FDX/HDX
RING PORT
COMUPLER 
PORT
MODE
1 2 3 4 5 6 7 8 9
STAT
FAULT
PWR1
MASTER
PWR2
COUPLER
LNK/ACT SPEED FDX/HDX
RING PORT
COMUPLER 
PORT
MODE
1 2 3 4 5 6 7 8 9
STAT
FAULT
PWR1
MASTER
PWR2
COUPLER
LNK/ACT SPEED FDX/HDX
RING PORT
COMUPLER 
PORT
MODE
1 2 3 4 5 6 7 8 9
1. For each switch in the ring,
select any two ports as the
redundant ports.
2. Connect redundant ports on
neighboring switches to form
the redundant ring.
The user does not need to manually assign the master with Turbo Ring or Turbo Ring V2. If no
switch is assigned as the master, the protocol automatically selects one of the switches to be the
master. The master is only used to identify which segment in the redundant ring acts as the backup
path. In the following subsections, we explain how the redundant path is selected for rings
configured for Turbo Ring and Turbo Ring V2.
Determining the Redundant Path for Turbo Ring
In this case, the redundant segment (i.e., the segment that will be blocked during normal operation)
is determined by the number of PT series Ethernet switches in the ring and by the location of the
master switch.
Turbo Ring with even number of switches
Master
STAT
FAULT
PWR1
MASTER
PWR2
COUPLER
LNK/ACT SPEED FDX/HDX
RING PORT
COMUPLER 
PORT
MODE
1 2 3 4 5 6 7 8 9
STAT
FAULT
PWR1
MASTER
PWR2
COUPLER
LNK/ACT SPEED FDX/HDX
RING PORT
COMUPLER 
PORT
MODE
1 2 3 4 5 6 7 8 9
STAT
FAULT
PWR1
MASTER
PWR2
COUPLER
LNK/ACT SPEED FDX/HDX
RING PORT
COMUPLER 
PORT
MODE
1 2 3 4 5 6 7 8 9
STAT
FAULT
PWR1
MASTER
PWR2
COUPLER
LNK/ACT SPEED FDX/HDX
RING PORT
COMUPLER 
PORT
MODE
1 2 3 4 5 6 7 8 9
If the number of Ethernet switches
in the Turbo Ring is 2N (an even
number), the backup segment is
one of the two segments connected
to the (N+1)st switch (i.e., the unit
directly opposite the master).