User`s manual

PT-G7509 User’s Manual Featured Functions
3-85
Monitor by Port
Access the Monitor by Port function by selecting ALL Gigabit Ports from the left pull-down list.
The Gigabit port options are identical to the Monitor by System function discussed above, in that
users can view graphs that show All Packets, TX Packets, RX Packets, or Error Packets activity,
but in this case, only for an individual port.
The All Ports option is essentially a graphical display
of the individual port activity that can be viewed with the Console Monitor function discussed
above. The All Ports option shows three vertical bars for each port. The height of the bar
represents Packets/s for the type of packet, at the instant the bar is being viewed. That is, as time
progresses, the height of the bar moves up or down so that the user can view the change in the rate
of packet transmission. The blue colored bar shows Uni-cast packets, the red colored bar shows
Multi-cast packets, and the orange colored bar shows Broad-cast packets. The graph is updated
every few seconds, allowing the user to analyze data transmission activity in real-time.
Using the MAC Address Table
This section explains the information provided by the PT-G7509’s MAC address table.
The MAC Address table can be configured to display the following PT-G7509 MAC address
groups.
ALL Select this item to show all PT-G7509 MAC addresses
ALL Learned Select this item to show all PT-G7509 Learned MAC addresses
ALL Static Select this item to show all PT-G7509 Static/Static Lock /Static
Multicast MAC addresses
ALL Static
Multicast
Select this item to show all PT-G7509 Static Multicast MAC
addresses
Port x Select this item to show all MAC addresses of dedicated ports