User`s manual
Table Of Contents
- 1. Introduction
- 2. Getting Started
- 3. Featured Functions
- Configuring Basic Settings
- Using Port Trunking
- Configuring SNMP
- Using Communication Redundancy
- Using Traffic Prioritization
- Using Virtual LAN
- Using Multicast Filtering
- Using Bandwidth Management
- Using Port Access Control
- Using IP Filter
- Using Auto Warning
- Using Line-Swap-Fast-Recovery
- Using Set Device IP
- Using Diagnosis
- LLDP
- Using Monitor
- Using the MAC Address Table
- Using System Log
- Using HTTPS/SSL
- A. MIB Groups
- B. Specifications
- C. Modbus/TCP Map
PT-7728 User’s Manual Featured Functions
3-77
NOTE
The following events will be recorded into the PT-7728’s Event Log table, and will then be
sent to the specified Syslog Server:
y Cold start
y Warm start
y Configuration change activated
y Power 1/2 transition (Off Æ On), Power 1/2 transition (On Æ Off)
y Authentication fail
y Topology changed
y Master setting is mismatched
y Port traffic overload
y dot1x Auth Fail
y Port link off / on
Using HTTPS/SSL
To secure your HTTP access, the PT-7828 supports HTTPS/SSL to encrypt all HTTP traffic.
Perform the following steps to access the PT-7828’s web browser interface via HTTPS/SSL.
1. Open Internet Explorer and type https://PT-7828’s IP address in the address field. Press
Enter to establish the connection.
2. Warning messages will pop out to warn the user that the security certificate was issued by a
company they have not chosen to trust.
3. Select Yes to enter the PT-7828’s web browser interface and access the web browser interface
secured via HTTPS/SSL.
NOTE
Moxa provides a Root CA certificate .After installing this certificate into your PC or Notebook,
you can access the web browser interface directly and will not see any warning messages again.
You may download the certificate from the PT-7828A’s CD-ROM.