User`s manual
Table Of Contents
- 1. Introduction
- 2. Getting Started
- 3. Featured Functions
- Configuring Basic Settings
- Using Port Trunking
- Configuring SNMP
- Using Communication Redundancy
- Using Traffic Prioritization
- Using Virtual LAN
- Using Multicast Filtering
- Using Bandwidth Management
- Using Port Access Control
- Using IP Filter
- Using Auto Warning
- Using Line-Swap-Fast-Recovery
- Using Set Device IP
- Using Diagnosis
- LLDP
- Using Monitor
- Using the MAC Address Table
- Using System Log
- Using HTTPS/SSL
- A. MIB Groups
- B. Specifications
- C. Modbus/TCP Map
PT-7728 User’s Manual Featured Functions
3-75
The table will display the following information:
MAC This field shows the MAC address
Type This field shows the type of this MAC address
Port This field shows the port that this MAC address belongs to
Using System Log
Event Log
Bootup This field shows how many times the PT-7728 has been rebooted or cold started.
Date The date is updated based on how the current date is set in the Basic Setting
page.
Time The time is updated based on how the current time is set in the Basic Setting
page.
System
Startup Time
The system startup time related to this event.
Events Events that have occurred.
NOTE
The following events will be record into PT-7728’s Event Log Table.
y Cold start
y Warm start
y Configuration change activated
y Power 1/2 transition (Off Æ On), Power 1/2 transition (On Æ Off)
y Authentication fail
y Topology changed
y Master setting is mismatched
y Port traffic overload
y dot1x Auth Fail
y Port link off / on