User`s manual
Table Of Contents
- 1. Introduction
- 2. Getting Started
- 3. Featured Functions
- Configuring Basic Settings
- Using Port Trunking
- Configuring SNMP
- Using Communication Redundancy
- Using Traffic Prioritization
- Using Virtual LAN
- Using Multicast Filtering
- Using Bandwidth Management
- Using Port Access Control
- Using IP Filter
- Using Auto Warning
- Using Line-Swap-Fast-Recovery
- Using Set Device IP
- Using Diagnosis
- LLDP
- Using Monitor
- Using the MAC Address Table
- Using System Log
- Using HTTPS/SSL
- A. MIB Groups
- B. Specifications
- C. Modbus/TCP Map
2
2
Chapter 2 Getting Started
This chapter explains how the initial installation process for the PT-7728. There are three ways to
access PT-7728’s configuration settings: the serial console, Telnet console, and web console. If
you do not know the PT-7728’s IP address, you can open the serial console by connecting the
PT-7728 to a PC’s COM port with a short serial cable. You can open the Telnet or web console
over an Ethernet LAN or over the Internet.
The following topics are covered:
Serial Console Configuration (115200, None, 8, 1, VT100)
Configuration by Telnet Console
Configuration by Web Browser
Disabling Telnet and Browser Access