User`s manual
Table Of Contents
- 1. Introduction
- 2. Getting Started
- 3. Featured Functions
- Configuring Basic Settings
- Using Port Trunking
- Configuring SNMP
- Using Communication Redundancy
- Using Traffic Prioritization
- Using Virtual LAN
- Using Multicast Filtering
- Using Bandwidth Management
- Using Port Access Control
- Using IP Filter
- Using Auto Warning
- Using Line-Swap-Fast-Recovery
- Using Set Device IP
- Using Diagnosis
- LLDP
- Using Monitor
- Using the MAC Address Table
- Using System Log
- Using HTTPS/SSL
- A. MIB Groups
- B. Specifications
- C. Modbus/TCP Map
PT-7728 User’s Manual Featured Functions
3-8
Global Unicast Address
Setting Description Factory Default
None Display an IPv6 Global Unicast address. The
network portion of a Global Unicast address
can be configured by specifying the Global
Unicast Prefix and using a EUI-64 interface ID
in the low order 64 bits. The host portion of a
Global Unicast address is automatically
generated using the modified EUI-64 form of
the interface identifier (the switch’s MAC
address)
Link-Local Address
Setting Description Factory Default
None The network portion of a Link-Local address is
FE80 and the host portion of a Link-Local
address is automatically generated using the
modified EUI-64 form of the interface
identifier (the switch’s MAC address)
FE80: (EUI-64
form of the MAC
address)
Neighbor Cache
Setting Description Factory Default
None The information in the neighbor cache includes
the neighboring node IPv6 address, the
corresponding Link-Layer address, and the
current state of the entry.
None