User`s manual
Table Of Contents
- 1. Introduction
- 2. Getting Started
- 3. Featured Functions
- Configuring Basic Settings
- Using Port Trunking
- Configuring SNMP
- Using Communication Redundancy
- Using Traffic Prioritization
- Using Virtual LAN
- Using Multicast Filtering
- Using Bandwidth Management
- Using Port Access Control
- Using IP Filter
- Using Auto Warning
- Using Line-Swap-Fast-Recovery
- Using Set Device IP
- Using Diagnosis
- LLDP
- Using Monitor
- Using the MAC Address Table
- Using System Log
- Using HTTPS/SSL
- A. MIB Groups
- B. Specifications
- C. Modbus/TCP Map
PT-7728 User’s Manual Featured Functions
3-3
Password
The PT-7728 provides two levels of configuration access. The admin account has read/write
access of all configuration parameters, and the user account has read access only. The user
account can only view the configuration, but will not be able to make modifications.
ATTENTION
By default, no password is assigned to the PT-7728’s web, Telnet, and serial consoles. If a
password is assigned, you will be required to enter the password when you open the serial
console, Telnet console, or Web console.
Account
Setting Description Factory Default
Admin This account can modify the PT-7728's
configuration.
admin
User This account can only view the PT-7728's
configurations.
Password
Setting Description Factory Default
Old password
(max. 16 characters)
Enter the current password None
New password
(Max. 16 characters)
Enter the desired new password. Leave it blank if
you want to remove the password.
None
Retype password
(Max. 16 characters)
Enter the desired new password again. Leave it
blank if you want to remove the password.
None