User`s manual

PT-7324 Series User’s Manual Featured Functions
configuration settings to their factory default values. This function can be accessed from the
RS-232 Console, or Web Browser interface.
NOTE
After activating the Factory Default function, you must use the default network settings to
re-establish a web-browser connection with your Moxa PowerTrans Switch.
Using Bandwidth Management
A single device should not be allowed to occupy unlimited bandwidth, especially when the device
malfunctions. For example, broadcast storms could be caused by an incorrect topology or
malfunctioning device. The PT-7324 series not only prevents broadcast storms, but can also
configure the ingress rate of unicast/multicast/broadcast packets, giving administrators full control
of the limited bandwidth, and preventing unpredictable faults before they occur.
Broadcast Strom Protection
Setting Description Factory Default
Enable/Disable
The PT-7324 will drop broadcast packets (Destination
MAC address is “ff ff ff ff ff ff”) after the received
broadcast packets counter reaches 64. The counter is
reset to 0 every 800 ms, or when a non-braodcast
packet (Destination MAC address is not “ff ff ff ff ff
ff”) is received.
Enable
Configuring Traffic Rate Limiting
3-7