User`s manual

CN2510 User’s Manual Administrative Utilities
14-6
Routing
1. From the MONITOR MENU, select Routing, and then press Enter.
CN2510-8 CN2510-8_5631 V2.0
------------------------------------------------------------------------------
Line Network Async async-Setting [Routing] PPP-Trace Quit
Monitor current routing table
ESC: back to menu Enter: select
Iface Destination Gateway/HA Netmask Metric Flag Use
eth0 0.0.0.0 192.168.1.3 0.0.0.0 15 UGT+ 0
eth0 201.2.2.0 203.67.6.251 255.255.255.0 1 UGT 0
eth0 203.65.66.0 203.67.6.252 255.255.255.0 2 UGT 0
eth0 0.0.0.0 203.67.6.254 0.0.0.0 1 UGT 9
eth0 192.168.0.0 192.168.2.180 255.255.0.0 1 U 389
lo17 192.168.2.180 * * 0 UH
Iface: Name of the physical network interface.
Destination: Network or host that the router allows you to connect to.
Gateway: IP Address of the gateway you configured for this route. If you are directly
connected, this is a local address. Otherwise, it is the address of the machine
through which packets must be routed.
Netmask: Network pattern of the gateway.
Metric: Number of hops to the destination.
Flags: State of the route. Valid states are:
U up
D down
G route to a gateway
H route to a host
T setting in route table
R dynamic by RIP
Use: Correct number of packets being sent in this route.
2. Press Esc to return to Routing.
PPP-Trace
1. From the MONITOR MENU, select PPP-Trace, and then press Enter.
CN2510-8 CN2510-8_5631 V2.0 MONITOR MENU
------------------------------------------------------------------------
Line Network Async async-Setting Routing [PPP-Trace] Quit
Trace PPP protocol connect messages
Enter: select ESC: previous menu