User`s manual

CN2510 User’s Manual Setting Up Multiplexor
12-10
Setting Value Notes Necessity
Quit Key ^E Defines the Quit key used to disconnect
the link between the current terminal
session and the remote host. It may be
left blank for binary communication.
Optional
Auto-link protocol None/Telnet/
Rlogin
None: Do not connect to the host
automatically.
Telnet: Connects to the host
automatically by Telnet.
Rlogin: Connects to the host
automatically by Rlogin.
Optional
Telnet TCP port 23 By default, the Telnet TCP port number
is set to 23, which is the default TCP port
number for Telnet. If you need to telnet
to this CN2510 serial port, set the Telnet
TCP port to a different number. We
recommend using 4001, 4002, etc. for
ports 1, 2, etc. to avoid conflicts with
other ports.
Required
Primary host IP IP address or
the name
defined in the
[Host] table
If specified, designates a ‘permanent’
host to which the terminal will always be
connected.
Optional
Link by input IP Enable/
Disable
For users to enter the connection IP
address manually.
Optional
Secondary host IP IP address or
the name
defined in the
[Host] table.
If specified, designates a secondary
‘permanent’ host to which the terminal
will be connected.
Optional
Auto-login prompt ogin: Send ID information when this prompt is
received.
Optional
Password prompt assword: Send Password information when this
prompt is received
Optional
Login user name Login ID Optional
Login password Login Password Optional
Terminal type ansi Terminal type for outgoing connection Optional
Inactivity time 0-99 minutes Idle time before the port is disconnected
automatically. If set to 0 minutes, the
port will not disconnect.
Optional
Authentication
type
None/local/
server
None: Authentication is not required.
local: Check the ID stored in the
User_table (defined under the SERVER
MENU).
Server: Check the ID with the
external RADIUS server. Refer to
Appendix C for RADIUS installation
information.
Optional