User`s manual

Note that the above screen applies to a 1-port NPort Express with Op-
erating Mode set to Pair-Connection. If the Operating Mode is set to
Host-Based, the only configurable setting is Tx FIFO.
The other options are as follows:
• RS-422/485 Interface RS-422 or RS-485
• RS-485 Comm.Mode ADDC, BX RTS
• Baud Rate 15 specific rates from 50 bps up to
230400 bps
(Pair-Connection Mode only)
• Parity None, Odd, Even
• Data Bit 5, 6, 7, 8
• Stop Bit 1, 1.5, 2
• Flow Control None, RTS/CTS, XON/XOFF
• Alive timeout any value between 0 and 99 min.
(Pair-Connection Mode only)
• Tx FIFO Disable, Enable
When all of the settings are correct, press the Esc key to return to the
MAIN MENU.
Diagnostic
This function simply checks the status of the network connection by
running an
• Asynchronous port controller test, and
• Asynchronous port loopback test.