User`s manual

Note the three tabs, Select Port, Select Item, and General, lo-
cated towards the top of the window. The Select Port tab will be
selected by default, and the program will find all NPort Expresses
currently connected to the network.
2. From the Server IP Address pull down menu, select the server(s)
that you want to monitor. The server information will appear in the
Monitoring NPort Server info box.
.Note: Click the Search button before selecting a server from the pull
down list if you add more NPort Expresses after the Diagnostics
utility is initiated. Otherwise the new server will not be listed in
the pull down list.
3. The check box for all ports needing to be monitored should be
checked (refer to the figure in step 2). For those ports that no
longer need monitoring, click inside the checked box to remove
the check mark.
4. If you need to delete some servers from the list, highlight the serv-
ers to be deleted, and then click on the Delete Server button in the
lower left hand corner of the Monitor configuration window.