User`s manual

3. The Replace Server window that opens up shows a list of servers
that have not been configured. The new server can be identified by
looking at the serial number.
4. Use the pop up window to confirm the Server.
5. If the new server is password protected, enter the pre-set password
when prompted to do so.
6. Click OK to save the current settings to the new server.
7. Click on Save Configuration to activate.
.Note: Previous configurations, including server name and port settings,
are retained after going through the above described Replace Server
procedure. However, the server password will be set to the one you
entered during the replacement procedure, so you will need to start
using the new password to access the server.
Custom Mode
Driver and Software Installation
1. Insert the NPort Server Express disk into either the floppy disk
drive or CD ROM drive, depending on the type of disk that was
provided.
From the Start Menu, choose Run.