Setup guide

GRAVIMETRIC GATEWAY AND ETHERNET COMMUNICATIONS

12. Press 2, Baud rate

Select (9) other, Input the baudrate as 1200 and press. Enter.

Note: Some earlier firmware versions were unable to set the baud rate to 1200 baud by

selecting (1)1200 due to a bug in firmware. Therefore we recommend using (9) other

and entering 1200.

13. Press Esc to return to return to the previous menu. You will see:

0.Exit 1.Overview 2.Networking 3.Security 4.Com1 5.WLAN

Input choice and enter(0~5):

14. Press 5, WLAN. You will see:

WLAN:

Associated: non-spec: 44:44:44:44:44:44

Current channel: : 10

Current Tx Rate: 2 Mbps

1. Topology(Infrastucture):

2. Transmission Rate(1 Mbps):

3. Ad-hoc Channel 1~14(3):

4. ESSID():

5. WEP(OFF):

Input choice and enter(1~5):

15. Press 2, Transmission Rate

Set Transmission Rate to 1 Mbps (press 1)

(Note: 1 Mbps was found to provide the best signal with greater distance and was less

susceptible to interference.)

16. Press 4, ESSID

Set your ESSID (SSID) to your wireless network's SSID. (example G2-WIRELESS)

17. Press 5, WEP

18. Press 3, wep128

19. Input Key No 1~4, press 1 (you will enter a 128-bit key into key #1)

20. You will see a format example and “Please input 13 bytes:

Enter your 128-bit WEP key and press enter.

Note: Prefix your WEP with 0x (Hex indicator)

Example: 0x31323334353637383930414243

WLAN WEP: 31323334353637383930414243