Setup guide

GRAVIMETRIC GATEWAY AND ETHERNET COMMUNICATIONS
27
I. On the next screen, review your settings. If they are correct, click Yes. If
they are not correct, exit the wizard and restart this section again.
Advanced Wireless Setting Changes
A. Open a web browser such as Internet Explorer.
B. Enter the IP address of your WAP11 into the address field. Example:
http://192.168.1.251 (replacing 192.168.1.251 with your IP address).
C. When prompted for a user name and password, leave the username blank
and enter the default password admin
D. You should be presented with a web page of Setup information.
E. On the SETUP page, Under AP Mode select Repeater
F. In the Remote repeater MAC Address, enter the MAC address of the
wireless device you want to repeat. Typically this might be the WAP11
Access Point.
G. Click Apply
H. Click the advanced tab at the top of the page.
I. Click the Wireless tab at the top of the page.
J. Change the Basic Rates to 1-2(Mbps)
K. Change the Transmission Rates: to 1-2(Mbps)
L. Change the SSID Broadcast: to Disable
M. Click Apply
N. At this time if you want to change the password to the WAP11, you can
click the Setup tab at the top of the screen and then click the Password tab.
To change the password, enter a new password and once again to confirm
it. Click Apply. You will be prompted to re-enter your password.
At this time you have completed the configuration of the WAP11 as a repeater and may close
the web browser.