Setup guide

GRAVIMETRIC GATEWAY AND ETHERNET COMMUNICATIONS
25
STEP 2 – Setup of the WAP11 Repeater
A. Insert the Linksys Setup Wizard CD-
ROM into your CD-ROM drive. (This
CD is included with the Linksys WAP11
Wireless Access Point). The Setup Wizard
should run automatically, and the
Welcome screen should appear. If it does
not, click the Start button and choose
Run. In the box that appears, enter
d:\setup.exe (where “D” is the drive letter of your CD-ROM drive). To set up
your Wireless Ethernet Bridge, click the
Setup button.
B. Make sure your WAP11 is connected to
your wired network so that you can
configure the WAP11 through any PC on
your wired network. Then Click Next.
C. The next screen displayed will have a list
of Wireless Access Points on your
network, along with the status
information of each access point. Select
the WAP11 that to configure by clicking
it’s name. Then click Yes.
D. On the Enter Network Password screen,
enter the Access Point’s default password,
admin, in the password field. Then click
Ok.