Setup guide

GRAVIMETRIC GATEWAY AND ETHERNET COMMUNICATIONS

Advanced Wireless Setting Changes to the WET11

A. Open a web browser such as Internet Explorer.

B. Enter the IP address of your WET11 into the address field. Example:

http://192.168.1.225 (replacing 192.168.1.225 with your IP address).

C. When prompted for a user name and password, leave the username blank and

enter the default password admin

D. You should be presented with a web page of LAN and wireless settings. Scroll

to the bottom of that page and click Advanced Wireless Settings.

E. A new browser window should pop up with advanced wireless settings.

Change the Transmit Rate to 1 then click apply, and then Ok. Close the

advanced settings window.

F. If you wish to change the password of the WET11 at this time, click the

Password tab. Enter a new password and enter it again to confirm. Click

Apply. You should be prompted for a password again. Enter Admin as the

user name and enter your new password.

G. Configuration of the WET11 is complete. Close the browser window.