Setup guide

GRAVIMETRIC GATEWAY AND ETHERNET COMMUNICATIONS

the code used when logging a wireless device onto the wireless network. The

passphrase is case-sensitive and should not be longer than 16 alphanumeric

characters. This passphrase will be used with the WAP (wireless access point)

and the WAP in repeater mode. When complete, click the Next button.

J. On the WEP Key Settings screen, you

will see the automatically generated

WEP key. This key should be

recorded so that it may be used later

when configuring the Wireless Serial

Servers. Click next.

K. Review your settings. If these settings

are correct, click the Yes button. If

any of these settings are wrong, click

the Back button to make changes.

The basic configuration is complete.

To activate the new settings, reset the

Bridge by turning off the Bridge

(unplug), wait a few seconds and

turning it back on again. Further

setting changes will be required and the

WET11 will need to be access via a web browser to make the necessary setting

changes.