Setup guide

GRAVIMETRIC GATEWAY AND ETHERNET COMMUNICATIONS
17
F. This screen shows a choice of two
wireless modes. Since a wireless G2
network will require an access point,
select Infrastructure Mode and click
next.
G. The Basic Settings screen will now
appear. Enter your wireless network
SSID.
For this example we are using
G2-WIRELESS. For Infrastructure
Mode, the Channel will not be selected.
Enter a unique Bridge Name for this
Wireless Ethernet Bridge device. Click
next.
H. The IP Settings screen will now appear.
It is recommended that the G2
network have static IP addresses. Click
the radio button next to Set IP
configuration manually. Enter an IP
Address, IP Mask (also known as
Subnet Mask), and Gateway for your
network. If you are unsure about the
IP Mask and Gateway, it is better to leave these two fields blank. Click next to
proceed.
I. The Security Setting screen will appear.
Set the Wired Equivalent Privacy
(WEP) encryption for your wired
network. It is recommended that you
use the 128-bit WEP configuration
method.
For 128-bit WEP, enter a passphrase in the Passphrase field. A passphrase is