Setup guide

GRAVIMETRIC GATEWAY AND ETHERNET COMMUNICATIONS
16
STEP 2 – Setup of the WET11 Wireless Bridge
A. Insert the Linksys Setup Wizard CD-ROM into your CD-ROM drive. (This
CD is included with the Linksys WET11 Wireless Ethernet Bridge). The Setup
Wizard should run automatically, and the Welcome screen should appear. If it
does not, click the Start button and choose Run. In the box that appears, enter
d:\setup.exe (where “D” is the drive letter of your CD-ROM drive).
B. To set up your Wireless Ethernet Bridge,
click the Setup button.
C. This screen shows two ways to configure
the WET11 using this Setup Wizard. For
this example, the way that the WET11
will be used is the B. configuration. Click
the Next button.
D. The Setup Wizard will search for any
WET11 Wireless Bridges connected to the
PC or to the network. It will then display
a list of WET11 Bridges found on your
network. If you have only one Bridge
connected to your network, it will be the
only one displayed. Select the Bridge you
are currently installing by clicking its name
in the Selection box. Click the Yes button.
E. For security purposes, you will be asked for your
password in order to access the Bridge. In
lowercase letters, enter admin in the Password
field. Click the Ok button.