Setup guide

GRAVIMETRIC GATEWAY AND ETHERNET COMMUNICATIONS

Wireless Ethernet Bridge (WET11)

This configuration setup guide will follow the WET11’s Quick

Installation Guide, packaged with the WET11 and include the

recommended settings for configuring the WET11 for wireless G2

communications.

How the WET11 is used in the G2 network:

• Converting a G2 Server PC or G2 Client PCs to 802.11b wireless

• Can be used in combination with the G2-ES to convert the G2-ES to wireless

What you will need to know to configure this device:

! IP address, Subnet Mask and Gateway for the WET11

! SSID – Network name used on for your wireless bridge (must be the same on all

wireless devices)

! Wired Equivalent Privacy WEP (128-bit recommended) – Secure passphrase will be

entered

Configuration: (Note: Linksys Screen shots may differ from this documentation)

STEP 1 – Connecting the WET11 Wireless Bridge

A. Plug the included Ethernet network cable into the LAN port on the back panel of the

WET11 Wireless Ethernet Bridge.

B. The X-II selection offers a choice between two settings. Slide the X-II selection switch

to the X position if you are connecting the WET11 directly to the network card of the

G2 Server or G2 Client or directly to the G2-ES. Slide the X-II selection switch to the

II position if you are connecting the WET11 to a hub or switch.

C. Plug the other end of the Ethernet network cable into your RJ-45 port on your G2

Server (or G2 Client), or into an open port on your network hub or switch.

D. Plug the supplied power cable into the Power port on the back panel of the WET11.

Then plug the other end into an electrical outlet.

Linksys

WET11

Wireless Ethernet

Bridge.