Setup guide

GRAVIMETRIC GATEWAY AND ETHERNET COMMUNICATIONS
12
Wireless diagram 3 – In this
diagram the G2 Server’s Ethernet
is connected to the WET11
Wireless Bridge (crossover cable
not required, use
X
-
II
switch).
Each Maguire Controller has a
Wireless Serial Server. The G2
communications are transmitted
via wireless from the WET11, to
the WAP11, and then to each
Wireless Serial Server. The
primary reasons for using a
wireless bridge (WET11) to
centrally locate the WAP11 in the
wireless network for better
performance.
Wireless diagram 4 – In this
diagram the G2 Server’s Ethernet
is connected to an existing local
area network. The WAP11 is also
connected to the local area
network. Each Maguire
Controller has a Wireless Serial
Server. G2 communications are
sent across the network and then
transmitted via wireless between
the WAP11, and then to each
Wireless Serial Server. G2 Client
machines are able to access the G2
Server via the local area network.
In this as well as all diagrams,
repeaters may be used to improve
performance of the wireless
network.