Setup guide

GRAVIMETRIC GATEWAY AND ETHERNET COMMUNICATIONS

the Transmission Rate, the lesser the distance we were able to communicate. It was

found that the lowest setting of 1 Mbps achieved the best results.

The following diagrams illustrate several possible wireless networks.

Wireless diagram 2 – In this

diagram the G2 Server’s Ethernet

port is connected directly to the

WAP11’s Ethernet port using a

crossover cable. Each Maguire

Controller has a Wireless Serial

Server. The wireless signal is

boosted by a WAP11 in Repeater

Mode located between the G2

Server and the controllers. The

G2 communications are

transmitted via wireless from the

WAP11, repeated by the WAP11

in Repeater Mode, and then to

each Wireless Serial Server. The

Repeater may also be used to re-

establish communications in a

“dead spot” in the wireless

Wireless diagram 1 – This is the

most basic wireless layout. In this

diagram the G2 Server’s Ethernet

port is connected directly to a

WAP11’s Ethernet port using a

crossover cable (or sometimes

referred to as a station-to-station

cable). The WAP11 converts the

G2 Server’s Ethernet

communication to wireless. Each

Maguire Controller has a Wireless

Serial Server. The G2

communications are transmitted

wireless between the WAP11 and

each Wireless Serial Server.