User`s manual

NPort S8000 Series Switch Featured Functions
6-30
Configuring Virtual LAN
VLAN Settings 802.1Q VLAN
To configure the NPort S8000’s 802.1Q VLAN, use the VLAN Setting page to configure the ports.
VLAN Mode
Setting Description Factory Default
802.1Q VLAN Set VLAN mode to 802.1Q VLAN 802.1Q VLAN
Port-based VLAN Set VLAN mode to Port-based VLAN
Management VLAN ID
Setting Description Factory Default
VLAN ID ranges from 1
to 4094
Set the management VLAN of this NPort S8000. 1
Port Type
Setting Description Factory Default
Access This port type is used to connect single devices without tags. Access
Trunk Select “Trunk” port type to connect another 802.1Q VLAN
aware switch or another LAN that combines tagged and/or
untagged devices and/or other switches/hubs.
ATTENTION
For communication redundancy
in the VLAN environment, set “Redundant Port,” “Coupling Port,” and
“
Coupling Control Port” as “Trunk Port,” since these ports act as the “backbone” to transmit all packets of
different VLANs to different NPort S8000 unit
s.
Port PVID
Setting Description Factory Default
VID range from 1 to
4094
Set the port default VLAN ID for untagged devices
that connect
to the port.
1
Fixed VLAN List (Tagged)
Setting Description Factory Default
VID range from 1 to
4094
This field will be active only when selecting the “Trunk” port
type. Set the other VLAN ID for tagged devices that connect
to
the “Trunk” port. Use commas to separate different VIDs.
None