User`s manual

NPort S8000 Series Introduction
1-3
Product Features
The NPort S8000 Series products enjoy the following features:
• Make your serial devices Internet ready
• Versatile socket operation modes, including TCP Server, TCP Client, and UDP
• Easy-to-use Windows Utility for mass installation
• Supports 10/100 Mbps Ethernet—auto detectable
• Supports SNMP MIB-II for network management
• Configuration auto-restore by LLDP (Link Layer Discovery Protocol)
• Configurable serial data transmission priority
• Multi-port managed Ethernet switch
• Ethernet redundancy by Turbo Ring (recovery time < 20 ms), RSTP/STP (IEEE 802.1w/D)
• QoS, IGMP snooping/GMRP, VLAN, LACP, SNMPv1/v2c/v3, RMON supported
• 4 serial ports device server, support RS-232/422/RS-485
• 2K VDC isolation protection for serial port
• Surge protection for serial/power/Ethernet
• Adjustable pull high/low resistor and Terminators for the RS-485 port
• 2- or 4-wire RS-485 with patented ADDC™ (Automatic Data Direction Control)
• Built-in 15 KV ESD protection for all serial signals
Product Specifications
General Specifications
Port Summary
Serial Ports:
4 RS-232/422/485 ports
Ethernet Switch Ports:
3 RJ45
copper ports and 2 multi-mode fiber ports
Console Ports:
1 (8-pin RJ45 connector)
Physical Characteristics
Housing:
Metal
Weight:
995 g
Dimensions:
73.1 x 134 x 105 mm (2.88 x 5.27 x 4.13 in)
Environmental Limits
Operating Temperature:
Standard Mode
ls: 0 to 60°C (32 to 140°F)
Wide Temp. Models:
-
40 to 75° C (-40 to 167° F)
Storage Temperature:
-40 to 85°C (-40 to 185°F)
Ambient Relative Humidity:
5 to 95% (non-condensing)
Power Requirements
Input Voltage:
12 to 48 VDC
Power Consumption:
935 mA @ 12 V, 470 mA @ 24 V
Standards and Certifications
Safety:
UL 508, UL 60950-1, EN 60950-1
EMC:
CE, FCC
EMI:
EN 55022 Class A, FCC Part 15 Subpart B Class A